Hypermac Moulder Series

Machine Information

9″, 10.2″, 12″, 13″ or 15.75″ Widths; 1/4″- 6″, 8″ or 10″ Thickness

  • 1 to 11 Heads
  • Feed Speeds to 120 or 150 FPM
  • Full Sound & Safety Enclosure with internal lighting system
  • One-piece, cast iron machine frame is specially heat treated for standard configurations
  • Extra Heavy Feed Beam supported at each end of the beam on 2 large supporting columns
  • Feed system is Chainless Full HD Cardan Shafft Drive with very heavy gearboxes and universals
  • Faster Feed Speeds of up to 120fpm(40m/min) are standard and to 150fpm(45m/min)
  • Pneumatic pressure of the Top Feed Rolls can be easily set to provide the best feed rool pressure. Separate Pressure controls for top Infeed, Midfeed & Outfeed Rolls
  • Pneumatic Pressure – easily adjusted to Side head Holdover Rolls as well as the Top Head Chipbreaker(s)
  • Precision Spindle Assemblies each including 4 Super Precision Bearings for highest tolerances and Outboard Hydro-Loc Bearing Assemblies on wider machines
  • Spindles Speeds are std. 6,000rpm and 7,200rpm/8,000rpm are optional
  • Each spindle is driven by an individual motor for powerful machinging and easy control
  • REC Setworks – Programmable controller provides convenient thickness & width of cut settings. More Powered Top & Full Width Bottom Rolls then most of our competition. (See Optional SmartSet Controls listed below and in separate section)
  • Hard-Chrome Plating to all Table Surfaces, Chip Breakers, Pressure Plates and Main Guide for maximum wear resistance
  • Digital Counters on all heads Axial and Radial as well as counters on Chip Breakers & Pressure Plate(s)
  • Automatic Table Lube System included
  • Central Grease Lubrication System – lubrication points located from front of machine
  • Electrics to UL/CSA Standards and are 230/460 or 575/3/60 – can convert to single phase and other voltages optional